![]() ! - Make sure the policy number is not used ! > Define IKEv2 Phase 1/Main Mode policy ! > General IKEv2 configuration - enable IKEv2 for VPN ![]() Nat (inside,outside) source static destination static Azure- Azure. ! > No NAT required between the on-premises network and Azure VNet ! This access list defines the IPsec SA traffic selectors.Īccess-list Azure-acl extended permit ip object-group object-group Azure. ! > Specify the access-list between the Azure VNet and your on-premises network. ! network properties (address prefixes, VPN device IP, BGP ASN, etc.)ĭescription On-Premises network prefixes ! In Azure network resource, a local network gateway defines the on-premises ! > Object group that corresponding to the prefixes. ! > Object group that consists of all VNet prefixes (e.g., 10.11.0.0/16 &ĭescription Azure virtual network prefixes ! (2) Construct traffic selectors as part of IPsec policy or proposalĪccess-list outside_access_in extended permit ip host host ! (1) Allow S2S VPN tunnels between the ASA and the Azure gateway public IP address ! > Most firewall devices deny all traffic by default. ! > on the inside interface or vlan e.g., 10.51.0.1/24 ! > address on the outside interface or vlan ! (*) Must be unique names in the device configuration ! - => Replace it with the actual nexthop IP address ! - => Replace it with appropriate netmasks ! - => Replace it with a private IP address if applicable ! on-premises network, specifies network prefixes, device public IP, BGP info, etc. ! - * => LocalNetworkGateway - the Azure resource that represents the ! - Interface names - default are "outside" and "inside" ! Replace the following place holders with your actual values: Sample script ! Sample ASA configuration for connecting to Azure VPN gateway
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |